42
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
May, 2023.
LED Behavior: WPS Functionality
Pressing the WPS button once initiates the primary pairing mode (allows mobile Wi-Fi clients
to connect to the RG).
Pressing and holding the button for three seconds initiates Wi-Fi backhaul pairing mode
(allows Wi-Fi satellites to connect to the RG).
After pressing the button, the WPS feature stays in pairing mode for 120 seconds. During
this time, you can pair Wi-Fi client devices or satellites to the RG by also using the WPS
function on those devices or systems.
Sequence of WPS operation
1. Press the WPS button a single time (or hold 3+ seconds in a 10-second window). The
RG enters pairing mode for up to 120 seconds.
2. If another WPS device is found, the system pairs with the device. If no found, the system
exits pairing mode after 120 seconds.
Note: Based on the model being deployed, LED size and/or orientation may be different
(however behavior is unchanged).
Status Function LED Status
Pairing
Attempt
Started
Enable WPS upon pressing the WPS a single time. The device
will stay in pairing mode for 120 seconds.
Behavior: LED begins flashing at 500 m/sec intervals and
continues for at most 120 seconds.
Device Not
Found
If no device is found after the initial 120 second time-out, the
WPS/Strength LED bar shifts from the blinking green to solid red.
Behavior: LED remains red for another 60 seconds, then reverts
to the normal status.
To Next Page
Loading...
