Calsense ET2000e - Page 31

® SECTION 5: WEATHER
making
since 1986
w
ater work
2. Press the PLUS or MINUS keys to
change the settings.
The WIND GAGE SETUP screen will change to
reveal the irrigation wind settings (Figure 5.15).
WIND GAGE? YES
Is Controller Wired to a
than 15 MPH
WIND GAGE SETUP
PAUSE IRRIGATION when wind is higher
Respond to Wind by Program
RESUME IRRIGATION when wind is less
than 10 MPH
Figure 5.15
Note:
The pause and resume irrigation default
settings are 15 MPH to pause and 10 MPH to
resume.
3.
Press the blue ARROW keys to
move the cursor to the next entry
(Figure 5.16).
WIND GAGE? YES
than 15 MPH
Is Controller Wired to a
WIND GAGE SETUP
PAUSE IRRIGATION when wind is higher
Respond to Wind by Program
RESUME IRRIGATION when wind is less
than 10 MPH
Figure 5.16
To change the wind speed that you want the
irrigation to pause at:
4.
Press the PLUS or MINUS keys
(Figure 5.17).
5.
Press the blue ARROW keys to
move the cursor to the next entry.
To set the Miles Per Hour that you want the
controller to resume irrigation at, (Figure 5.17).
WIND GAGE? YES
than 15 MPH
than 10 MPH
Is Controller Wired to a
WIND GAGE SETUP
PAUSE IRRIGATION when wind is higher
Respond to Wind by Program
RESUME IRRIGATION when wind is less
Figure 5.17
6.
Use the PLUS or MINUS keys to
change the speed (Figure 5.17).
5C.2 Respond to Wind by Program
1.
Press the RESPONED TO WIND BY
PROGRAM Menu key.
The USE OF WIND BY PROGRAM screen is
displayed (Figure 5.18).
PROG A . . . . . . . . . . . . . . . . . . . . YES
When the wind speed is highe
r
USE OF WIND BY PROGRAM
than 15 MPH irrigation will be PAUSED.
DRIP 2 . . . . . . . . . . . . . . . . . . . . YES
Allow WIND to pause the following:
PROG B . . . . . . . . . . . . . . . . . . . . YES
PROG C . . . . . . . . . . . . . . . . . . . . YES
PROG D . . . . . . . . . . . . . . . . . . . . YES
PROG E . . . . . . . . . . . . . . . . . . . . YES
DRIP 1 . . . . . . . . . . . . . . . . . . . . YES
Figure 5.18
You can select the programs that you want to be
affected by wind. The default setting is YES. If you
do not
want programs to be affected by wind
change the setting to NO for the appropriate
program.
2. Press the PLUS or MINUS keys to
change the settings.
3.
Press the blue ARROW key to
move the cursor to the next entry.
4.
Press the MAIN MENU key to return
to the MAIN MENU screen
(Figure 5.1).
THIS CONCLUDES THE WIND GAGE SETUP
SECTION