Calsense ET2000e - Alerts

® SECTION 6: REPORTS
making
since 1986
w
ater work
(Table: 0 Reports: 0): These two values appear in
(Figure 6.6) and are defined as follows:
• Table: Shows the amount of usable rain
pulses recorded during the last hour period,
that will be applied to irrigation.
• Reports: Shows the amount of total rain,
during the last one hour period.
Note: The number in the upper right hand corner of
the screen (represented by a 3 in Figure 6.6) is the
total recorded ET gage pulses in the last 24 hours.
6E. ALERTS
Alerts are a chronological listing of each individual
event that has taken place, or changes that have
been made to the controller. They can be viewed at
the controller physically or obtained from the
controller via communication. The Alerts section of
the controller allows you to view the controller alerts
in the following arrangements:
• All Alerts.
• Weather.
• Communications
• Changes (alterations made by the key pad
or use of Command Center software).
• Irrigation.
• Status View.
• Go To Top (Returns the highlight cursor to
the top of the current list of alerts being
viewed).
From the REPORTS menu screen (Figure 6.2):
1.
Press the ALERTS Menu
key.
Note:
If the “ALERTS TO SEE” menu key is
available on the STATUS screen when the ALERTS
MENU key is pressed it will cause the MOST
RECENT ALERTS screen to come up, if not the
ALERTS screen will appear as in figure 6.7.
The ALERTS screen is displayed (Figure 6.7).
11/18 1:10AM END: Pro
g
rammed Irri
g
ation
4 Total Alerts - on 1 of 4
(
ALL
)
11/18 9:51AM Radio Remote Enabled (norm)
11/18 9:52AM Radio Remote Finished (***
11/18 12:10AM START: Programmed Irrigation
(Use "*" key for other views)
Figure 6.7
2. Press the PLUS or MINUS keys
to scroll up and down the list.
Note: Press the STAR key to access the
WHICH ALERTS TO SEE screen which will give you
a presorted view of the alerts based on alert type
(Figure 6.8).
WHICH ALERTS TO SEE
Weather Communications
Status View Changes
Go To Top All
Irrigation
Figure 6.8
3. Press the appropriate Menu
key to access the alerts that
you want to see.
Note:
Alerts can also be accessed when the
“ALERTS TO SEE” menu key appears on the
STATUS screen (Figure 6.9).
Note: From the STATUS screen pressing the
ALERTS TO SEE menu key will allow you to view
the alerts listed under the STATUS VIEW
arrangement (Figure 6.9).
STATUS
(live screens ) ( adjust stations )
No Stations are Watering
PROGRAMED IRRIGATION WILL RUN
12:00AM on Sunday Apr 2, 2006
ALERTS TO SEE
0 GPM 0.00 AMPS
Mar 28 2006
Tue 10:50:25AM
Figure 6.9
THIS CONCLUDES THE ALERTS SECTION
THIS CONCLUDES THE ET & RAIN TABLES
SECTION