Calsense ET2000e - Manual Key; Manual Watering

SECTION 10: MANUAL KEY ®
making
since 1986
w
ater work
SECTION 10: MANUAL KEY
The Manual section of the controller is used for:
• Manual Watering stations
• Testing individual stations
• Master Valve Override
• Learning station expected flow rates
• Manual Programs
• Walk-Thru
• Use Hold Over
1.
Press the MANUAL key.
The MANUAL MENU screen is displayed
(Figure 10.1).
MANUAL MENU
Manual Watering Manual Program 1
Test Manual Program 2
Learn Expected Use Hold - Ove
r
MV Override Walk - Thru
Figure 10.1
10A. MANUAL WATERING
The Manual Watering section of the controller is
used to manually water individual stations, or all
stations within a program using total timed irrigation
or cycle and soak.
1. Press the MANUAL WATERING
Menu key.
The MANUAL IRRIGATION screen is displayed
(Figure 10.2).
Manual Water Station 1 for 3.0 mins
MANUAL IRRIGATION
Cycle & Soak During Manual ? NO
Manual Water ALL Stations
Figure 10.2
10A.1 Manual Water a Station
From the MANUAL IRRIGATION screen (Figure
10.2):
1.
Press the PLUS or MINUS keys
to change the station number.
2.
Press the MANUAL WATER
STATION # FOR #.## MINS
Menu key.
The IRRIGATION FOR STATION # screen is
displayed (Figure 10.3).
IRRIGATION for STATION 1
Manually Watering ( mv open-pump off )
1.9 Min of 4.0 Min Cycle
Details
Figure 10.3
Note: Pressing the DETAILS Menu key will
take you to the IRRIGATION DETAILS screen
where you can view, or clear the station.
(See Section 6 REPORTS / IRRIGATION
DETAILS).
10A.2 Manual Water a Program
From the MANUAL IRRIGATION screen
(Figure 10.2):
1.
Press the PLUS or MINUS keys
to change the program selection.
2. Press the MANUAL WATER
PROG # STATIONS Menu key
to activate watering of all stations
for selected program.
The IRRIGATION FOR STATION # screen will
appear for each station as it irrigates (Figure 10.3).