1 Introduction
1.1 Check the parts and drawing
Before you start installing please read this installation manual.
Check the received parts for transport damage.
Next, study carefully the installation drawing that comes with the lift to ensure that all
dimensions are correct and corresponds to the installation site.
1.2 Electrical installation
If the drawing does not show where to install the Control boxes, please sort out where
they all go. Make sure that the electrical supply and electrical wiring for the Handi-Lift
are there before installing the tower and lift.
You need 1x230V with earth, 3x1,5 mm². The installation must be protected by a 10
Amp fuse and RCCB 30 mA. We recommend that you make a measurement of the
earth connection.
We recommend that you make a measurement of the earth connection.
Fig. 1
To Next Page