Introduction
Instruction Manual, Nov-17 2
• When working with the fluids of the instrument, be sure to take the appropriate
caution (protect your eyes from direct contact with liquid)
• The instrument may be used only by properly trained laboratory staff
• The instrument may not be used in rooms with danger of explosions
• The instrument contains highly sophisticated electronics. It may be operated only
in a non-condensing atmosphere in the temperature range outlined in the chapter
"Technical data". Before installation and use, the instrument should be acclimated
properly
• Use a damp lint free cloth for cleaning the instrument surface. Do not employ
aggressive detergents
• Protect yourself and the instrument from electrostatic shock which can cause
damage to the electronic parts
• Only authorized personnel may open the instrument. Service and repair is only to
be performed by trained specialists. Use spare parts and consumables supplied by
CAMAG only. The warranty is voided if parts from other sources are used. Check
the service manual before you start service to reduce product-specific risks
• The power cord has to be removed before the instrument is opened. It is not
permitted to work on an instrument that has been opened and is connected to the
power supply
• Spare fuses must be of the type specified by the instrument manufacturer. It is
forbidden to short-circuit or manipulate fuses
• Use only the original power cord type that is delivered with the instrument
• If the instrument is found to be defective, it must be switched off and steps must
be taken to ensure that it cannot be switched on by mistake
• If liquids penetrate the inside of the instrument, the power has to be disconnected
immediately. Small amounts of liquid can be wiped off and/or dried by means of a
hairdryer, with larger amounts of liquid a service technician has to be called. A test
of functionality has to be performed in all cases
• Carry out all safety checks and the preventive maintenance as recommended by
the manufacturer in order to assure your personal safety and the full functionality
of the instrument. Have an authorized service specialist perform any service not
described by this manual
• See original manufacturers' manuals for further safety data on third party
equipment supplied with the system
• Lift/move/transport the system with the necessary care and with sufficient
manpower (install the transport security devices if applicable, transport it only in
the original packaging)
To Next Page
