Cambium Networks PTP 700 User Manual (English)

UGPS Product Description and Overview133
Figure 66 UGPS Connector Interface134
UGPS Power Source Configurations135
- External Power Only135
- Figure 67 Power Pinout - UGPS Ethernet Power Cable135
- Figure 68 PMP 100 AP Receiving Synchronization from External-Powered UGPS136
- Figure 69 PMP 320 Receiving Synchronization from External-Powered UGPS137
- Figure 70 One PMP 400/430 AP and One PMP 100 AP Receiving Synchronization from External-Powered UGPS138
- Figure 71 Power Pinout - UGPS to AP/BHM Timing Port (6-Pin RJ-11)139
- Power from the Radio Via UGPS Timing Port 1 or UGPS Timing Port 2139
- Figure 72 AP/BHM to UGPS Cable140
- Table 26 AP/BHM to UGPS Cable Pinout140
- Figure 73 PTP 230 Backhaul Master Powering UGPS and Receiving Synchronization141
- Figure 74 PMP 450 AP Powering UGPS and Receiving Synchronization142
- Figure 75 Two PTP 230 Backhaul Master Units Powering UGPS and Receiving Synchronization143
- Figure 76 PTP 230 Backhaul Master Powering Ugps/Receiving Synchronization and PMP 100/430 Receiving Synchronization144
UGPS and CMM Configurations145
Product Specifications146
UGPS Installation and Operation147
Table 27 Compatible 30V Power Supplies and Cords147
Figure 77 UGPS to CMM Cable Pin Configuration148
Table 28 Cable Length Specification148
UGPS Installation Procedure149
Figure 79 Configuring the Sync Input and Disabling UGPS Power - PMP 100/400/430 and PTP 100/200 Series149
Figure 80 Configuring the Sync Source - PMP 320 Series149
Figure 82 CMM Port Conifguration for UGPS Power152
IP Default Bypass153
Table 29 UGPS IP Default Bypass Wiring153
Table 30 UGPS IP Default Bypass Wiring153
Figure 83 IP Default Bypass - Default Radio on Timing Port 1154
Figure 84 IP Default Bypass - Default Radio on Timing Port 2155
GPS Status and Location Data Readout156
- Retrieving GPS Status and Location Data Via Radio Web Management GUI156
- Figure 85 GPS Status and Location Data - PMP 430 Example156
- Retrieving GPS Status and Location Data Via SNMP157
- Table 31 GPS SNMP Oids - PMP 100/400/430 and PTP 100/200/230 Series158
- Table 32 GPS SNMP Oids - PMP 320 Series159
UGPS Power Port and Timing Port Pinouts160
Table 33 UGPS Power Port Pinout160
Table 34 UGPS Timing Port Pinout160

Chapter 5: CMM Regulatory and Legal Notices161

Chapter 6: UGPS Regulatory, Legal, and Safety Notices170

Modulation	QPSK, 16QAM, 64QAM, 256QAM
Range	Up to 200 km
Latency	< 5 ms
Encryption	AES-128, AES-256
IP Rating	IP67
Channel Width	20, 40 MHz
Power Supply	48V
Operating Temperature	-40 to +55 °C
Ethernet Interface	10/100/1000 Mbps

Cambium Networks PTP 700 User Manual

Table of Contents

Cambium Networks PTP 700 Specifications

Related product manuals