Page 5 - Manual code: FB00162-EN vers. 1 07/2015 © CAME s.p.a. - The data and information shown in this manual are to be considered as subject to change at any time and without the need for any advance warning.
Page
4 - Manual code: FB00162-EN vers. 1 07/2015 © CAME s.p.a. - The data and information shown in this manual are to be considered as subject to change at any time and without the need for any advance warning.
Access the settings web page by entering the address of the de-
vice that you wish to configure in the address bar of your browser
(Chrome, Firefox, Safari).
Select the [INSTALLER] login mode and enter the password (de-
fault password: 112233) to access the settings screens.
The [USER] login mode (default password: 123456) lets you:
1) consult the following pages
2) update the firmware.
There is no scroll bar on the right on the settings web pa-
ges. To scroll through the web pages, press and hold
down the left mouse button and drag. On a smartphone or
tablet, drag your finger across the screen.
System information
This window gives technical information to identify the device's
characteristics, the hardware and software versions, and the SIP
account status.
Network
MAC ADDRESS
MAC ADDRESS of the device cannot be changed
MODE
Lets you choose the type of address from:
DHCP the IP address of the device is assigned by the DHCP ser-
ver (for future uses);
Static (default) the IP address of the device is manually assigned.
IP ADDRESS
If you chose to use a static IP, enter the IP address of the device,
which must belong to the same subnet as the router and the
other devices connected (default address: 192.168.1.5).
NETMASK
If it is dierent from the default, give the subnet mask.
GATEWAY
Should it be necessary to route data trac towards other sub-
nets, you can indicate a gateway.
To save the changes or reload the previous data, press the button
that will appear at the bottom of the page.
Select SIP from the list.
••••••
SETTINGS
LOG-IN MODE
USER
INSTALLER
PASSWORD
Language Enter
System Info
System Info
Help Exit
MODEL
SN
HW VERSION
SW VERSION
ACCOUNT STATUS
Date and Time
DVC IP
Registered
0X00801234
1.0
1.2.3
Network
SIP
Panel
Maintenance
Calls list
Diagnostic
Network
Help Exit
MAC ADDRESS
MODE
IP ADDRESS
NETMASK
GATEWAY
Static
System Info
Date and Time
Network
SIP
Panel
Maintenance
Calls list
Diagnostic
To Next Page
Loading...
Need help?
General
