Pag. 11 - - 02/2021 - © CAME S.p.A.
Setting the operating modes
The first time you switch the device on, it will launch in WIRELESS GATEWAY ACCESS POINT
mode to be configured with your home Wi-Fi network.
To change operating modes from WIRELESS GATEWAY to BLUETOOTH SELECTOR, press and
hold the change mode button for 3 s.
To return to WIRELESS GATEWAY mode, press and hold the button for 3 s.
To RESET the Wi-Fi parameters, press and hold the change mode button for 10 s. All of the
LEDs are on.
Key for change mode button
Button pressed for 3 s
Mode change: Wi-Fi (green LED) / BLUETOOTH
(blue LED).
Button pressed for 10 s
Reset Wi-Fi parameters (red, green and blue
LEDs on).
Button pressed for 20 s
Restore factory settings.
Button pressed 3 times in 5 s Start / stop WPS.
Configuration
Wireless GATEWAY mode
Check that the CAME GW device is in Wi-Fi mode (green LED on).
Requirements for managing an operator using a CAME GW device:
- create a CAME CONNECT account
- associate the CAME GW device with the CAME CONNECT account
- configure the CAME GW device to the home network so that it can be connected to the internet
(if your router has a WPS, this feature can be used to associate the device with the router. Please
follow the instructions shown in the SetUp app).
- add an operator.
☞ Download the CAME SetUp app onto your smartphone or tablet (search SETUP in the manual
which you can download here http://docs.came.com).
The list of compatible operators is available at the following link:
http://www.cameconnect.net/
came/docs/cameconnect_compliant_devices.html
.
BLUETOOTH SELECTOR mode
Check that the CAME GW device is in BLUETOOTH mode (blue LED on).
Download the CAME AUTOMATION BT app for Android or iOS onto your smartphone or tablet
(search AutomationBT in the manual which you can download here http://docs.came.com).
To Next Page
Loading...
Need help?
General
