p.
- Manual:
FA00613-EN v.
1 - 11/2016 - © CAME S.p.A. The data and information in this manual may be changed at any time and without notice.
WARNING!
important safety instructions for people:
READ CAREFULLY!
PREMISE
• THIS PRODUCT SHOULD ONLY BE USED FOR THE PURPOSE FOR WHICH IT WAS
EXPLICITLY DESIGNED. ANY OTHER USE IS DANGEROUS. CAME S.P.A. IS NOT LIABLE
FOR ANY DAMAGE CAUSED BY IMPROPER, WRONGFUL AND UNREASONABLE USE •
T
HE SAFETY OF THIS PRODUCT AND ITS PROPER FITTING DEPENDS, THEREFORE, ON
RESPECTING ITS TECHNICAL CHARACTERISTICS AND PROPER FITTING, TO BE DONE IN
STATE-OF-THE-ART FASHION, AND UNDER SAFE CONDITIONS AS EXPRESSLY EXPLAINED
IN THE LITERATURE THAT COMES WITH THE PRODUCT • KEEP THESE WARNINGS
TOGETHER WITH THE INSTALLATION AND OPERATION MANUALS THAT COME WITH THE
OPERATOR.
B
EFORE INSTALLING
(CHECKING WHAT'S THERE: IF SOMETHING IS MISSING,
DO NOT CONTINUE UNTIL YOU HAVE COMPLIED
WITH
ALL SAFETY PROVISIONS)
• FITTING AND TESTING MUST BE BE ONLY PERFORMED BY QUALIFIED TECHNICIANS
•
LAYING THE CABLES, INSTALLATION AND TESTING MUST FOLLOW STATE-OF-THE-ART
PROCEDURES AS DICTATED BY REGULATIONS • BEFORE BEGINNING ANY OPERATION IT
IS MANDATORY TO CAREFULLY READ ALL INSTRUCTIONS; IMPROPER INSTALLATION MAY
RESULT IN SERIOUS HARM TO PEOPLE AND THINGS.• MAKE SURE THE OPERATOR IS IN
GOOD MECHANICAL STATE, BALANCED AND ALIGNED, AND THAT IT OPENS AND CLOSES
PROPERLY. ALSO, IF NEEDED, FIT SUITABLE PROTECTIONS O USE PROPER SAFETY SEN-
SORS • MAKE SURE THAT THE OPENING TURNSTILE CANNOT RESULT IN ANY HAZARDS
•
DO NOT INSTALL THE OPERATOR ONTO SURFACES THAT COULD YIELD AND BEND.
I
F NECESSARY, ADD SUITABLE REINFORCEMENTS TO THE ANCHORING POINTS • ONLY
INSTALL ON A LEVEL SURFACE • MAKE SURE ANY SPRINKLER SYSTEMS CANNOT WET
THE OPERATOR FROM THE GROUND UP.
I
NSTALLING
• SUITABLY SECTION OFF AND DEMARCATE THE ENTIRE INSTALLATION SITE TO PREVENT
UNAUTHORIZED PERSONS FROM ENTERING THE AREA, ESPECIALLY MINORS AND CHIL-
DREN • BE CAREFUL WHEN HANDLING OPERATORS THAT WEIGH OVER 25 KG. IF NEED
BE, USE PROPER SAFETY HOISTING EQUIPMENT• THE CE-MARKED SAFETY DEVICES,
MUST BE FITTED IN COMPLIANCE WITH THE REGULATIONS IN EFFECT AND ACCORDING
TO STATE-OF-THE-ART CRITERIA, TAKING INTO ACCOUNT THE ENVIRONMENT, THE TYPE
OF REQUIRED SERVICE AND OF THE WORKING FORCES APPLIED TO MOVING TURNSTILES.
A
NY CRUSHING SHEARING OR CONVEYING POINTS MUST BE SUITABLY PROTECTED•
A
NY RESIDUAL RISKS MUST BE POINTED OUT TO END USERS AND HIGHLIGHTED WITH
PICTOGRAMS AS PROVIDED BY THE LAW • ALL OPENING COMMANDS (THAT IS, BUT-
TONS, KEY SWITCHES, MAGNETIC READERS, AND SO ON) MUST BE INSTALLED AT LEAST
1.85
M FROM THE PERIMETER OF THE TURNSTILE'S WORKING AREA, OR WHERE THEY
CANNOT BE REACHED FROM OUTSIDE THE TURNSTILE. ALSO, ANY DIRECT COMMANDS
(
BUTTONS, TOUCH PANELS, AND SO ON) MUST BE INSTALLED AT LEAST 1.5 M FROM
THE GROUND AND MUST NOT BE REACHABLE BY UNAUTHORIZED PERSONS • THE
TURNSTILE MUST CLEARLY DISPLAY ITS OWN IDENTIFICATION DATA • BEFORE CONNECT-
ING THE TURNSTILE TO THE POWER SUPPLY MAKE SURE THAT THE IDENTIFICATION DATA
MATCH THE NETWORK DATA • THE TURNSTILE MUST BE CONNECTED TO AN EFFICIENT,
STATE-OF-THE-ART GROUNDING SYSTEM • THE MANUFACTURER DECLINES ANY LI-
ABILITY FOR USING NON-ORIGINAL PRODUCTS; WHICH WOULD RESULT IN WARRANTY
LOSS • BEFORE DELIVERING TO THE USERS, MAKE SURE THE SYSTEM IS EN 12453
AND EN 12445 STANDARD COMPLIANT, AND ALSO MAKE SURE THE SYSTEM HAS
BEEN PROPERLY ADJUSTED AND THAT ANY SAFETY, PROTECTION AND MANUAL RELEASE
DEVICES ARE WORKING PROPERLY • APPLY WARNING SIGNS WHERE NECESSARY AND
IN A VISIBLE PLACE.
S
PECIAL INSTRUCTIONS
AND
RECOMMENDATIONS FOR USERS
• KEEP TURNSTILE OPERATION AREAS CLEAN AND FREE OF ANY OBSTRUCTIONS.
M
AKE SURE THE PHOTOCELL'S OPERATING FIELD IS CLEAR OF ANY OBSTRUCTIONS
•
DO NOT ALLOW CHILDREN TO PLAY WITH FIXED COMMANDS, OR TO LOITER IN THE
TURNSTILE'S MANEUVERING AREA. KEEP ANY REMOTE CONTROL TRANSMITTERS OR
ANY OTHER COMMAND DEVICE AWAY FROM CHILDREN, TO PREVENT THE OPERATOR
FROM BEING ACCIDENTALLY ACTIVATED • THE APPARATUS MAY BE USED BY CHILDREN
OF EIGHT YEARS AND ABOVE AND BY PHYSICALLY, MENTALLY AND SENSORY-CHAL-
LENGED PEOPLE, OR EVEN ONES WITHOUT ANY EXPERIENCE, PROVIDED THIS HAPPENS
UNDER CLOSE SUPERVISION OR ONCE THEY HAVE BEEN PROPERLY INSTRUCTED TO
USE THE APPARATUS SAFELY AND TO THE POTENTIAL HAZARDS INVOLVED. CLEANING
AND MAINTENANCE BY USERS MUST NOT BE DONE BY CHILDREN, UNLESS PROPERLY
SUPERVISED.• FREQUENTLY CHECK THE SYSTEM FOR ANY MALFUNCTIONS OR SIGNS
OF WEAR AND TEAR OR DAMAGE TO THE MOVING STRUCTURES, TO THE COMPONENT
PARTS, ALL ANCHORING POINTS, INCLUDING CABLES AND ANY ACCESSIBLE CONNEC-
TIONS. KEEP ANY HINGES, MOVING JOINTS AND FRICTION POINTS PROPERLY LUBRI-
CATED • PERFORM FUNCTIONAL CHECKS ON THE PHOTOCELLS AND SENSITIVE SAFETY
EDGES, EVERY SIX MONTHS. CONSTANTLY CLEAN THE PHOTOCELLS' GLASS COVERS
USING A SLIGHTLY WATER-MOISTENED CLOTH; DO NOT USE SOLVENTS OR CHEMICALS
THAT COULD DAMAGE THE DEVICES • IF REPAIRS OR MODIFICATIONS ARE REQUIRED TO
THE SYSTEM, CUT OFF THE MAIN POWER SUPPLY AND DO NOT USE IT UNTIL SAFETY
CONDITIONS HAVE BEEN RESTORED • CUT OFF THE POWER SUPPLY BEFORE PERFORM-
ING ANY MANUAL OPENINGS. IF THE POWER SUPPLY CABLE IS DAMAGED, IT MUST BE
REPLACED BY THE MANUFACTURER OR AUTHORIZED TECHNICAL ASSISTANCE SERVICE,
OR IN ANY CASE, BY SIMILARLY QUALIFIED PERSONS, TO PREVENT ANY RISK • IT IS
FORBIDDEN FOR USERS TO PERFORM ANY OPERATIONS THAT ARE NOT EXPRESSLY
REQUIRED OF THEM. FOR ANY REPAIRS, MODIFICATIONS AND ADJUSTMENTS AND FOR
EXTRA-ORDINARY MAINTENANCE, CALL TECHNICAL ASSISTANCE • LOG THE JOBS AND
CHECKS INTO THE PERIODIC MAINTENANCE LOG.
A
DDITIONAL INSTRUCTIONS AND RECOMMENDATIONS
FOR
EVERYONE
• KEEP AWAY FROM AND DO NOT LOITER NEAR THE BARRIER AND MECHANICAL MOV-
ING PARTS • DO NOT ENTER THE BARRIER'S AREA OF OPERATION WHEN IT IS MOVING
•
DO NOT COUNTER THE OPERATOR'S MOVEMENT AS THIS COULD RESULT IN DANGER-
OUS SITUATIONS • ALWAYS PAY SPECIAL ATTENTION TO ANY DANGEROUS POINTS,
WHICH HAVE TO BE LABELED WITH SPECIFIC PICTOGRAMS AND/OR BLACK AND YELLOW
STRIPES • WHEN USING A SELECTOR SWITCH OR A COMMAND IN MAINTAINED ACTION
MODE, KEEP CHECKING THAT THERE ARE NO PERSONS WITHIN THE OPERATING RANGE
OF ANY MOVING PARTS, UNTIL THE COMMAND IS RELEASED • THE TURNSTILE MAY
MOVE AT ANY TIME AND WITHOUT WARNING • ALWAYS CUT OFF THE MAINS POWER
SUPPLY BEFORE PERFORMING ANY MAINTENANCE OR CLEANING.
DANGER OF HAND CRUSHING
DANGER! HIGH VOLTAGE.
N
O TRANSITING WHILE THE BARRIER IS MOVING
To Next Page
Loading...
