PST001
PST002
PST003
p.
- Manual:
FA00613-EN v.
1 - 11/2016 - © CAME S.p.A. The data and information in this manual may be changed at any time and without notice.
Fix the turnstile with the screws using a ratchet wrench.
Attach the arms to the head of the tripod with screws M10x60 and flat head
washers.
Drill the marked holes and insert the dowels into
them.
The floor on which is fixed the turnstile must be
perfectly level.
Securing the turnstile
The turnstile anchoring spot depends on the size
of the gap and the possible accessories to be
connected. Once you have determined the location,
use a pencil to mark the drill holes according to the
dimensions indicated.
(mm)
Fit the tripod into the pin
and fix with screws M8x20 and cover
.
Place the turnstile over the dowels. If present, the
corrugated conduit for the passage of electric cables must
pass through the centre hole.
To Next Page
Loading...
