To achieve maximum performance and to prolong equipment life, it is important to have correct
installation and proper maintenance.
ORBIT Valves and Actuators are designed to require a minimum amount of maintenance.
Lubrication isn't necessary to effect a seal, only to reduce friction and wear on moving parts.
An effective lubrication program should be established from experience with the valve for its
particular application and frequency of operation.
ORBIT's recommended lubrication schedule should be used as a minimum guideline.
All ORBIT Valves are equipped with an adjustable stem packing chamber which is required only if
a stem leak should develop.
BEFORE YOU BEGIN
OTHER LITERATURE AVAILABLE
This manual outlines the correct methods for proper installation and maintenance of
ORBIT Valves and Actuators.
Step by step procedures should be followed closely to prevent damage to the valves
(and/or actuators) or injury to personnel.
This manual covers only installation, operation and maintenance of
ORBIT Valves and Actuators.
Other information includes:
VALVE REPAIR
ACTUATOR REPAIR
ACTUATOR SIZING GUIDE
PRODUCT INFORMATION
TECHNICAL CATALOG
Consult your Representative for additional information on Valves and Actuators.ORBIT ORBIT
WARNING
Valves are pressure containing vessels which can be dangerous if not
handled correctly.
DO NOT REMOVE ANYTHING ON THE VALVE OR ACTUATOR UNLESS
SPECIFICALLY INSTRUCTED TO DO SO IN THIS MANUAL, OR WITHOUT
FIRST CONSULTING AN ORBIT REPRESENTATIVE.
FAILURE TO DO SO COULD RESULT IN INJURY TO PERSONNEL AND
DAMAGE TO VALVE, ACTUATOR AND PROPERTY.
INSTALLATION, OPERATION AND MAINTENANCE
INTRODUCTION
P R O C E S S V A L V E S
CT-ORB-IOM/6
05/08 ION-3M
®
ORBIT
To Next Page
Loading...
