Why does the engine smoke on my Camon C6 Rotavators?
If the engine of your Camon Rotavator smokes, it could be due to petrol in the engine oil, possibly from leaving the fuel tap on during transportation. In this case, you should change the engine oil. Another possible cause is a contaminated air filter, which would require you to replace the element.
What to do if I am unable to pull the engine over on my Camon C6?
If you are unable to pull the engine over on your Camon Rotavators, it's possible that the machine was tipped on its side during cleaning, causing engine oil to fill the cylinder bore and create a hydraulic lock. To resolve this, remove the spark plug and air filter, stand to one side, and pull the engine over to clear out the oil. After this, change the engine oil and air filter, and clean the spark plug.
Why does my Camon Rotavators suddenly leap forward whilst cultivating?
If your Camon Rotavators suddenly leaps forward while cultivating, it could be due to several reasons. Firstly, check if a new set of tines has been fitted the wrong way round and refit them correctly if needed. Secondly, inspect the centre knife for wear or if it's missing, and replace it if necessary. Finally, if the centre knife is lifted too high on hard ground, lower it.
What to do if there is no drive to wheels or digging unit on Camon Rotavators?
If there is no drive to the wheels or digging unit of your Camon Rotavators, check the gearbox oil level and top up if necessary with API GL-5 80w/90 oil.
Why does my Camon Rotavators engine smoke?
Your Camon Rotavators engine might be smoking due to a couple of reasons. It's possible that petrol has leaked into the engine oil, often because the fuel tap was left on during transportation. If that's the case, changing the engine oil should solve the problem. Another potential cause is a contaminated air filter, so replacing the air filter element could also resolve the issue.
What to do if my Camon Rotavators machine suddenly leaps forward whilst cultivating?
If your Camon Rotavators leaps forward while cultivating, a few things could be happening. First, check if a new set of tines has been fitted the wrong way round and refit them correctly if needed. Also, the centre knife might be worn out or missing, so inspect it and replace it if necessary. Lastly, if the centre knife is lifted too high on hard ground, try lowering it.
What to do if I am unable to pull engine over on my Camon C6?
If you're unable to pull the engine over on your Camon Rotavators, it's possible that the machine was tipped on its side during cleaning, causing engine oil to fill the cylinder bore and create a hydraulic lock. To fix this, remove the spark plug and air filter, stand to one side, and pull the engine over to clear out the oil. After that, change the engine oil and air filter, and clean the spark plug.
What to do if there is no drive to wheels or digging unit on my Camon C6?
If there's no drive to the wheels or digging unit on your Camon Rotavators, check the gearbox oil level and top it up if necessary with API GL-5 80w/90 oil.
General| Brand | Camon |
|---|---|
| Model | C6 |
| Category | Rotavators |
| Language | English |
To Next Page
