received within 5 working days of product receipt or is incomplete, the product will be returned
to the customer at the customer’s expense. For details on decontamination standards specific to
your country, please reach out to your regional Campbell Scientific office.
NOTE:
All goods that cross trade boundaries may be subject to some form of fee (customs
clearance, duties or import tax). Also, some regional offices require a purchase order upfront
if a product is out of the warranty period. Please contact your regional Campbell Scientific
office for details.
Safety
DANGER — MANY HAZARDS ARE ASSOCIATED WITH INSTALLING, USING, MAINTAINING, AND WORKING ON OR AROUND TRIPODS,
TOWERS, AND ANY ATTACHMENTS TO TRIPODS AND TOWERS SUCH AS SENSORS, CROSSARMS, ENCLOSURES, ANTENNAS, ETC.
FAILURE TO PROPERLY AND COMPLETELY ASSEMBLE, INSTALL, OPERATE, USE, AND MAINTAIN TRIPODS, TOWERS, AND
ATTACHMENTS, AND FAILURE TO HEED WARNINGS, INCREASES THE RISK OF DEATH, ACCIDENT, SERIOUS INJURY, PROPERTY
DAMAGE, AND PRODUCT FAILURE. TAKE ALL REASONABLE PRECAUTIONS TO AVOID THESE HAZARDS. CHECK WITH YOUR
ORGANIZATION'S SAFETY COORDINATOR (OR POLICY) FOR PROCEDURES AND REQUIRED PROTECTIVE EQUIPMENT PRIOR TO
PERFORMING ANY WORK.
Use tripods, towers, and attachments to tripods and towers only for purposes for which they are designed. Do not exceed design limits.
Be familiar and comply with all instructions provided in product manuals. Manuals are available at www.campbellsci.com You are
responsible for conformance with governing codes and regulations, including safety regulations, and the integrity and location of
structures or land to which towers, tripods, and any attachments are attached. Installation sites should be evaluated and approved by a
qualified engineer. If questions or concerns arise regarding installation, use, or maintenance of tripods, towers, attachments, or electrical
connections, consult with a licensed and qualified engineer or electrician.
General
l
Protect from over-voltage.
l
Protect electrical equipment from water.
l
Protect from electrostatic discharge (ESD).
l
Protect from lightning.
l
Prior to performing site or installation work, obtain required approvals and permits. Comply with all governing structure-height
regulations, such as those of the FAA in the USA.
l
Use only qualified personnel for installation, use, and maintenance of tripods and towers, and any attachments to tripods and
towers. The use of licensed and qualified contractors is highly recommended.
l
Read all applicable instructions carefully and understand procedures thoroughly before beginning work.
l
Wear a hardhat and eye protection, and take other appropriate safety precautions while working on or around tripods and
towers.
l
Do not climb tripods or towers at any time, and prohibit climbing by other persons. Take reasonable precautions to secure tripod
and tower sites from trespassers.
l
Use only manufacturer recommended parts, materials, and tools.
Utility and Electrical
l
You can be killed or sustain serious bodily injury if the tripod, tower, or attachments you are installing, constructing, using, or
maintaining, or a tool, stake, or anchor, come in contact with overhead or underground utility lines.
l
Maintain a distance of at least one-and-one-half times structure height, 6 meters (20 feet), or the distance required by applicable
law, whichever is greater, between overhead utility lines and the structure (tripod, tower, attachments, or tools).
l
Prior to performing site or installation work, inform all utility companies and have all underground utilities marked.
To Next Page
Loading...
