Appendix A. Importing Short Cut code into CRBasic Editor 24
Appendix B. SDI-12 sensor support 25
B.1 SDI-12 command basics 25
B.1.1 Acknowledge active command (a!) 26
B.1.2 Send identification command (al!) 26
B.1.3 Start verification command (aV!) 27
B.1.4 Address query command (?!) 27
B.1.5 Change address command (aAb!) 27
B.1.6 Start measurement commands (aM!) 28
B.1.7 Start measurement commands with cyclic redundancy check (aMC! and aCC!) 28
B.1.8 Stopping a measurement command 29
B.1.9 Send data command (aD0! … aD9!) 29
B.2 SDI-12 transparent mode 29
B.2.1 Changing an SDI-12 address 30
Table of Contents - ii
To Next Page
Loading...