4. QuickStart
A video that describes data logger programming using Short Cut is available at:
www.campbellsci.com/videos/cr1000x-data logger-getting-started-program-part-3 . Short
Cut is an easy way to program your data logger to measure the sensor and assign data logger
wiring terminals. Short Cut is available as a download on www.campbellsci.com . It is included
in installations of LoggerNet, RTDAQ, and PC400.
The following procedure also shows using Short Cut to program the sensor.
1. Open Short Cut and click Create New Program.
2. Double-click the data logger model.
3. In the Available Sensors and Devices box, type MetSENS or locate the sensor in the Sensors
> Meteorological > Basic Weather > MetSENS folder. Double-click the appropriate sensor
model and output. Type the correct SDI-12 Address (default is zero) or Modbus Address
(default is 41). If measuring barometric pressure, type the elevation of the site in the same
units as the Site elevation units. Default units are meters, which can be changed by clicking
on the Site elevation units box and selecting Feet.
MetSENS-Series Compact Weather Sensors 2
To Next Page
Loading...