MAINTENANCE PROCEDURES
Suspension Lubrication
Rear Suspension
Lubricate swing arm pivots. Use
synthetic SUSPENSION GREASE
(P/N 293 550 033) or an equivalent.
vmo2006-014-061_a
LH SIDE OF VEHICLE
1. CVT duct
2. Grease fitting
Mechanical Brakes
(DS 90)
Mechanical Brake Inspe ction
WARNING
Any brake system repair should
be performed by an authorized
Can-Am De al er.
CAUTION The brakes can b e
very hot after prolonged use of the
vehicle and can cause burns. Wait
for the brakes to cool down.
Check brake lever free-play (both
levers), adjust if necessary.
Check for lever operation, they should
move freely and have a firm feel when
brakes are applied.
If co rrect adju stment is unattainable,
see an authorized Can-Am dealer for
cable replacement.
Inspect brake cables for excessive
wear, kink ing or fraying.
Replace any cable that show signs of
wear, fraying or other damages.
Lubricate cables using CABLE LUB RI-
CANT (P/N 293 600 041) to reduce
premature wear and to ensure proper
movement of the cable.
WARNING
Always use a silicone-based lu-
bricant. Using any other lubricant
(such as a water-based lubricant)
may cause the brake cables to stick
or become stiff.
Have your authorized Can-Am dealer
inspect brake shoes for wear or dam-
age.
BRAKE SHOE MINIMUM THICKNESS
FRONT AND
REAR
1.5 mm (.06 in)
See your authorized Can-Am dealer if
a problem is detected concerning th
e
brake system.
While reading this Operator’s Guide, remember that:
WARNING
Indicates a potential hazard that, if not avoided, could result in serious
injury or dea t h.
______________
101
To Next Page
Loading...
Need help?
General
