Candy CDCP 6 User Manual

How to Drain Excess Water From Hoses
If the sink is more than1000 mm higher than the floor, the excess water in hoses cannot be drained directly into the
sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and
lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres,otherwise the cleaning effect of the dishwasher could be reduced.
Start of dishwasher
The following things should be checked before starting the dishwasher.
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. Inlet hose connections are fully tightened and not leaking.
4. The wires are tightly connected.
5. The power is switched on.
6. The inlet and drain hoses are not kinked.
7. All packing and print materials should be taken out of the dishwasher.
Attention:
After installation, please make sure to keep this manual. The content of this manual is very helpful to the users.
9. Troubleshooting Tips
Before Calling for Service
Review the charts on the following pages may save you from calling for service.

Candy CDCP 6 Specifications

General

Door color	White
Door hinge	Standard
Product size	Compact
Built-in display	Yes
Custom panel-ready	-
Appliance placement	Freestanding
Cutlery compartment colour	Metallic grey
Upper basket adjustable height	No
Current	6 A
Power plug type	Type F (CEE 7/4)
AC input voltage	230 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Power consumption (off)	0.45 W
Water consumption per cycle	6.5 L
Energy consumption per cycle	0.61 kWh
Package depth	605 mm
Package width	555 mm
Package weight	24000 g
Cycle time	230 min
Noise level	51 dB
Drying system	Condensation
Delay start (max)	8 h
Number of place settings	6 place settings
Number of washing programs	6
Maximum hot water supply temperature	60 °C
Drying class	A
Annual energy consumption	174 kWh

Weight and Dimensions

Depth	500 mm
Width	550 mm
Height	438 mm
Weight	20600 g