Only use salt specifically designed for use in dishwashers! All other types of salt not specifically designed for
use in a dishwasher, especially table salt, will damage the water softener. in case of damages caused by the
use of unsuitable salt the manufacturer does not give any warranty nor is liable for any caused damages.
Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of
salt or salty water, which may have been split, remaining of the bottom of the machine for any period of time,
which may cause corrosion.
NOTE:
1. The salt container must only be refilled when the salt warning light in the control panel comes on. Depending on
how fully the salt dissolves, the salt warning light may still be on even though the salt container is filled.
If there is no salt warning light in the control panel (For some Models),you can judge when to load the salt into
the softener by the cycles that the dishwasher had run.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
Adjusting Salt Consumption
Step 1: Enter the status of salt adjustment
Close the door, within 60 seconds after power on, press button and hold for 5 seconds, the machine will enter setting
mode. Start/Pause
Step 2: select a certain level of salt consumption
Contact your local water board for information on the hardness of your water supply. Press the Start/pause button to
select the proper set according to your local environment, the sets will change in the following sequence: H1->H2-
>H3->H4->H5->H6;
Step 3: Exit the status of salt adjustment