EasyManuals Logo

Candy CS 1071DE-88 User Manual

Candy CS 1071DE-88
Go to English
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
!
EN
63
l Press the START/PAUSE button to start
the selected cycle.
l Once a programme is selected the
programme selector remains stationary on
the selected programme till cycle ends.
l Switch off the washing machine by
turning the selector to OFF.
l Press to start the selected cycle
(according to the selected cycle one of
the wash stage indicator lights will
illuminate).
PAUSING THE MACHINE
l Keep the START/PAUSE button pressed
for about 2 seconds (some light indicators
and the residual time display will flash,
showing that the machine is paused).
l Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE PROGRAMME
l To cancel the programme, set the
selector to the OFF position.
l Appliance start time can be set with this
button, delaying the start by 3, 6 or 9
hours.
l Proceed as follows to set a delayed start:
- Select a programme.
- Wait until the indicator lights related to
temperature and spin of the programme
selected light up.
- Press the delay start button (each time
the button is pressed the start will be
delayed by 3, 6 or 9 hours respectively
and the corresponding time indicator
light will blink).
Opening the door
A special safety device prevents the
door from being opened immediately
after the end of the cycle.
Wait for 2 minutes after the wash
cycle has finished and the "Door
Security" light has gone out before
opening the door.
PROGRAMME selector with OFF
position
When you select a programme the
indicator lights related to temperature
and spin of that cycle will light up.
N.B.: To switch the machine off, turn the
programme selector to the OFF
position.
The programme selector must be
returned to the OFF position at the end
of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
DELAY START button

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Candy CS 1071DE-88 and is the answer not in the manual?

Candy CS 1071DE-88 Specifications

General IconGeneral
BrandCandy
ModelCS 1071DE-88
CategoryWasher
LanguageEnglish

Related product manuals