Why my Candy RP 5106BWMBC/1-S does not work / start?
If your Candy Washer doesn't start, ensure it's plugged into a working socket and that the power is on. Test the socket with another appliance. Also, make sure the door is correctly closed, the program is properly selected, the start button is pressed, and that the machine isn't in pause or time delay mode.
What to do if water leaked on the floor near Candy RP 5106BWMBC/1-S Washer?
If you see water leaking near your Candy Washer, it could be from a faulty seal between the tap, supply hose, and fill valve. Try replacing the seal and tightening the hose connections. Also, check that the front filter is correctly closed.
What to do if Candy RP 5106BWMBC/1-S Washer does not spin?
If your Candy Washer isn't spinning, first remove and de-tangle the load, then reload and restart the spin program. Ensure that the water has completely drained. Also, check that the 'no spin' function isn't selected and that you're using the correct amount of detergent, as excessive detergent can impede the spin cycle. Check the selected options and their effect on the spin cycle. If the problem persists, refer to Error 3 section.
What to do if Candy RP 5106BWMBC/1-S shows error E3 (with display) 3 flashes of the LEDs (without display)?
If your Candy Washer displays error 'E3' or shows 3 LED flashes, check that the filter isn't clogged and that there are no foreign objects in the filter compartment. Ensure the drain hose isn’t bent or trapped and that the home drainage system isn't blocked. Try draining water in the sink to test the drainage.
Why Candy Washer does not work / start?
If your Candy Washer doesn't start, check these things: First, ensure the appliance is properly plugged into a working electrical outlet and that the power is on. Test the wall socket with another device, like a lamp, to confirm it's functioning. Make sure the door is completely closed. Also, verify that you've correctly selected the desired program and pressed the start button. Finally, check that the washer isn't in pause or time delay mode.
What to do if Candy Washer doesn't drain water?
If your Candy Washer isn't draining, start by checking the filter for clogs or foreign objects that might be blocking water flow. Also, make sure the drain hose isn't bent, kinked, or trapped. Finally, ensure that your home drainage system isn't blocked; try draining water into a sink to verify.
What to do if Candy RP 5106BWMBC/1-S Washer doesn't spin?
If your Candy Washer isn't spinning, it might be due to an unbalanced load. Remove the laundry, untangle it, reload it evenly, and restart the spin program. Also, ensure water has completely drained from the machine. Check if the 'no spin' function is selected. Excessive detergent usage can also prevent spinning, so use the correct amount.
What to do if Candy Washer leaked on the floor?
If you find water leaking near your Candy Washer, it could be leaking from the seal between the tap, supply hose, and fill valve. Replace the seal and tighten the hose connections properly. Also, make sure the front filter is correctly closed.
Why strong vibrations / noises are heard during the spin cycle of Candy RP 5106BWMBC/1-S Washer?
Loud noises or strong vibrations during the spin cycle of your Candy Washer may occur if the appliance isn't level. Adjust the feet as needed. Also, ensure that the transport screws, rubber bungs, and spacer tubes have been removed and that there are no foreign objects inside the drum.
How to fix Candy Washer error E2 (with display) 2 flashes of the LEDs (without display)?
If your Candy Washer displays 'E2' or the LEDs flash twice, ensure the water supply tap is open and the supply hose isn’t bent or trapped. Check that the drain pipe is at the correct height. Close the tap, unscrew the filler hose, and clean the anti-sand filter. Also, inspect the filter for clogs or foreign objects.
General| Type | Freestanding |
|---|---|
| Loading type | Front load |
| Capacity | 10 kg |
| Spin Speed | 1500 RPM |
| Dimensions (H x W x D) | 85 x 60 x 58 cm |
| Color | White |
| Noise level washing | 51 dB |
| Delay Start | Yes |
| Child Lock | Yes |
| Water Consumption | 51 L per cycle |
| Programs | Cotton, Synthetics, Delicates, Rapid 14/30/44 min, Wool |
To Next Page