! Rotating the programme selector in both
directions it's possible to select the
desired drying programme.
! To cancel the selections or switch off the
appliance rotate the programme selector
on OFF (remember to unplug the appliance).
! To start the selected cycle with the preset
parameters, press START/PAUSE. When
the programme is running, the display will
show the time to elapse.
! Moreover, if you want to modify the
chosen programme, press the desired
options buttons, modify the default
parameters and then press START/
PAUSE button to start the cycle.
! After switching on the appliance, wait a few
seconds for the programme to start running.
PROGRAMME DURATION
! When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
! Once the programme has started you will
be kept informed constantly of the time
remaining to the end of the drying cycle.
! The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to the
humidity level of the load.
PROGRAMME END
! "END" ("End" on some models) will
appear in the display at the end of the
programme, it is now possible to open the
door.
! At the end of the cycle, turn off the
appliance by turning the programme
selector to the OFF position.
PAUSING THE MACHINE
! Keep the START/PAUSE button pressed
for about 2 seconds (the residual time
display will flash, showing that the
machine is paused).
! Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
! To cancel the programme, turn the
programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
To Next Page
Loading...
