What to do if water leaked on the floor near Candy Washer?
To resolve water leakage near your Candy Washer, check the seal between the tap, supply hose, and fill valve; replace if leaking and tighten connections. Also, ensure the front filter is correctly closed.
What to do if Candy Washer displays error E3?
If your Candy Washer displays error E3 or 3 flashes, check that the filter isn't clogged and there are no foreign objects in the filter compartment. Ensure the drain hose isn’t bent or trapped. Also, verify that the home drainage system isn't blocked; try draining water in the sink to check.
Why Candy Washer makes noises during the spin cycle?
To address strong vibrations or noises during the spin cycle of your Candy Washer, first, ensure the washing machine is fully leveled by adjusting the feet. Next, check that transport screws, rubber bungs, and spacer tubes were removed. Finally, inspect the drum for any foreign objects like coins or buttons.
How to fix Candy Washer that does not spin?
If your Candy Washer isn't spinning, try these steps: remove and de-tangle the load, then reload and restart the spin program. Ensure water has completely drained; if the issue continues, refer to the Error 3 section. Also, check that the 'no spin' function isn't selected, and consider the effect of selected options on the spin cycle. Excessive detergent can also impede spinning, so use the correct amount.
What to do if Candy CSO 14105T3/1-S displays error E2?
If your Candy Washer displays E2 or 2 flashes, ensure the water supply tap is open and the supply hose isn’t bent or trapped. Check the drain pipe's height (see the installation section). Close the tap, detach the filler hose, and clean the “anti-sand” filter. Also, inspect the filter for clogs or foreign objects obstructing water flow.
How to fix Candy CSO 14105T3/1-S Washer error E7?
If your Candy Washer shows E7 or flashes 7 times, ensure the door is correctly closed and that clothes aren't preventing it from fully closing. If the door is locked, turn off and unplug the washer, wait 2-3 minutes, and then reopen the door.
Why Candy Washer displays error E4?
If your Candy Washer displays E4 or flashes 4 times, ensure you're using the correct amount of detergent designed for washing machines.
To Next Page
General