Cannon Fitzroy - INBUILT: CANTERBURY SPECIFICATIONS

Cannon Fitzroy / Canterbury Inbuilt | 7
INBUILT: CANTERBURY SPECIFICATIONS
Cannon Canterbury Inbuilt
FIG 4 Front View and Side View
298 mm850 mm
690 mm
700 – 790 mm
34 mm125 mm
655 mm
600 mm
Ceiling
Mantle 300 mm min clearance
900 mm min
clearance
Rear wall
380 mm
1000 mm min clearance
50 mm
clearance
Gas type Natural or Propane gas, as
indicated on data label
Gas consumption 26 MJ/hr input
Energy output 5.98 kW / 21.45 MJ/hr
Energy star rating 4.05 stars
Heater type Gas space heater approved to
AS4553:2008
Operating pressure
(at burner high setting)
Natural gas: 0.75 kPa
Propane gas 2.65 kPa
Gas regulator Integral part of controller
Min. inlet pressure 1.13 kPa (NG)
2.75 kPa (Propane)
Fan 3 speed
Ignition Electronic direct spark
Power requirement 240 VAC 10 Amp
Power consumption 90 VA maximum
Minimum cavity
dimensions
Height 605mm*
Width 700mm
Depth 385mm
Optional accessories •Safetymeshguard
•Remotethermostat
•Spacerkit
•3sidedsurround
•4sidedsurround
•Consolekit
Overall dimensions Refer to FIG 4
*For installation into a non-combustible fireplace, ie:
masonry or brick.
Please Note:
•Wheninstallingintoamockreplaceamock
fireplace installation kit must be used.
•Thedatalabelislocatedinthefanchamber.Access
by removing fascia.