BLM550+ Booklet Maker Service Support Guide
B. Watkiss P2T 2-Knife Trimmer for BLM550+ Training Course
To service the optional Watkiss P2T 2-Knife Trimmer for the BLM550+ Booklet
Maker, service technicians must complete the Watkiss P2T 2-Knife Trimmer for
the BLM550+ comprehensive blended learning program. The online course
module, available on Canon USA’s e-Support Center Web Site. The 3-day
Hardware classroom courses blends the information taught online with hands-
on, practical training in the classroom and lab.
The training for the Watkiss P2T 2-Knife Trimmer is a fee based course. To
order from Canon Network Access use item code 2115V542. The course fee is
$742.50.
Table 7 – Watkiss 2-Knife Trimmer Training Course
Watkiss P2T-2-knife Trimmer for BLM550+ eLearning Course
Watkiss P2T-2-knife Trimmer for BLM550+ Technical Training
1 Item Numbers and Part Numbers are subject to change without notice.
C. Prerequisites
Service technicians must successfully complete the VarioPrint
6XX0Ultra/TP/MICR Training Program.
D. Certification
• BLM 550+ Booklet Maker
Technician certification is required for authorization to sell these products and
to receive support.
E. Who Should Attend
It is highly recommended that any technician responsible for installing,
servicing, or supporting the BLM 550+ Booklet Maker complete the Training
Course.
Note: Our current support policy dictates that only those technicians who have
completed the training program and pass the final assessment exam are
entitled to live, phone-based support through our TSC (Technical Support
Center). However, self-service support (software downloads, knowledgebase
articles, support forums, technical publications) is available through our
e-Support Center Web Site for all technicians. (Refer to the Technical Support
section on the e-Support Center Web Site for entitlement details.)
BLM550+ Booklet Maker Service Support Guide March 2015
Revision 1 Page 6
To Next Page
Loading...