General support
Change the regional settings
Introduction
You can change the language, system of measurement, date and time, or time zone under the
regional settings on the operator panel.
Procedure
1.
On the operator panel, tap on the [System] icon on the right.
2.
Tap on [Regional settings].
3.
Change the language, system of measurement, date and time, or the time zone.
NOTE
You have to log in as System administrator to change some of the settings. For more
information, see
Log in as a System administrator
on page 271.
When time synchronization is enabled and the date and time of the printer is still out-
of-date, make sure the setting is configured correctly. For more information, see
Configure time synchronization
on page 274.
4.
Tap on [Save] to save the settings.
General support
302 Chapter 9 - Troubleshooting and support
To Next Page
Loading...
Need help?
General