7
Windows
Installing/Uninstalling the Software
Installing from the Canon Digital Camera Solution Disk
If you are installing the software onto Windows NT 4.0 or Windows 2000, you must first
log on as the administrator and then install the software.
Precaution about the USB Interface
• Ensure that you install the software from the Canon Digital Camera Solution Disk
onto the computer before you attach the camera to the computer’s USB port. If
you attach the camera to the USB port after installing the software, it will
automatically select the correct USB driver.
1. Close any programs that are running.
2. Place the Canon Digital Camera Solution Disk in the CD-ROM drive.
The installer panel will automatically display.
• If the installer panel does not automatically display, use the following procedures
to start it.
1. Double-click the [My Computer] icon on the desktop, and double-click the
CD-ROM icon in the next window.
2. Double-click the [Setup] icon.
3. Click [Software Installation].
4. Select the install location and click the [Next] button.
5. Select the software you wish to install and follow the on-screen
instructions to proceed.
6. Click the [Exit] button when the installation is complete and the installer
panel appears again.
To Next Page
Loading...
