Canon HF10 - Page 95

95
Recording
Pressing will not start recording.
- You cannot record while the camcorder is writing previous recording onto the memory (while the ACCESS
indicator is on or flashing).
- The memory is full or it already contains the maximum number of scenes. Delete some recordings
( 38, 59) or initialize the memory ( 29) to free some space.
The point where was pressed does not match the beginning/end of the recording.
- There is a slight interval between pressing and the actual start of recording. This is not a
malfunction.
The camcorder will not focus.
- Autofocus does not work on the subject. Focus manually (
44).
- Lens or Instant AF sensor is dirty. Clean the lens or sensor with a soft lens-cleaning cloth (
108). Never use
tissue paper to clean the lens.
When a subject flits across in front of the lens, the image appears slightly bent.
- This is a phenomenon typical of CMOS image sensors. When a subject crosses very quickly in front of the
camcorder, the image may seem slightly warped. This is not a malfunction.
Changing the operating mode between recording ( )/record pause ( )/playback ( ) takes longer than
usual.
- When the memory contains a large number of scenes, some operations may take longer than usual. Back up
your recordings ( 77) and initialize the memory ( 29).
Reviewing the last scene recorded takes longer than usual.
- When the memory contains a large number of scenes, some operations may take longer than usual. Back up
your recordings ( 77) and initialize the memory ( 29).
Cannot record a still image.
- In mode: You cannot record a still image if simultaneous recording (FUNC. menu) is set to [STILL I. REC
OFF] ( 62), or if either the digital zoom ( 87) or a digital effect ( 47) is activated.
Playback
Cannot add scenes to the playlist.
- You cannot add more than 999 scenes to the playlist.
- You may not be able to add scenes to the playlist if they were recorded or edited using another device.
Cannot delete a scene.
- You may not be able to delete scenes recorded or edited using another device.
Deleting scenes takes longer than usual.
- When the memory contains a large number of scenes, some operations may take longer than usual. Back up
your recordings ( 77) and initialize the memory ( 29).
Cannot erase a still image.
- The still image is protected. Remove the protection ( 64).
START/STOP
START/STOP
START/STOP
D128_PAL_E.book Page 95 Thursday, March 6, 2008 7:53 PM