1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
8-16
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Remote UI
You can set whether to enable the Remote UI to operate the
machine and change settings.
1. Press [Additional Functions].
2. Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using the numeric
keys, then press [Log In/Out (ID)].
3. Press [ ] or [ ] to select <REMOTE UI>, then
press [OK].
4. Press [ ] or [ ] to select <ON> or <OFF>,
then press [OK].
<ON>: You can specify settings and operate the machine through
the Remote UI.
<OFF>: You cannot specify settings and operate the machine
through the Remote UI.
5. Press [Stop/Reset] to return to the standby
mode.
The Remote UI is enabled only after you restart the machine.
(the main power switch is turned off, and then back on.)
To Next Page
Loading...
Need help?
General
