1
2
3
4
5
6
7
8
9
10
11
Back
Next
Previous
TOP
4-13
Before Using the
Machine
Document and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network
Remote UI
System Manager
Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
4 . Press [ ] or [ ] to select a one-touch key (01
to 08) or coded dial code (000 to 191) for which
you want to register the address, then press
[OK].
You can also select a one-touch key or coded dial code by pressing
the corresponding one-touch key, or [Coded Dial] followed by the
desired three-digit code.
5. Press [ ] or [ ] to select <SMB>, then press
[OK].
6. Press [ ] or [ ] to select <HOST NAME>,
then press [OK].
7. Use the numeric keys to enter the name of the
file server on the network (up to 120 characters),
then press [OK].
HOST NAME :1
canon01
Ex.
8. Press [ ] or [ ] to select <NAME>, then press
[OK].
9. Use the numeric keys to enter the destination’s
name (up to 16 characters), then press [OK].
10. Press [ ] or [ ] to select <FILE PATH>, then
press [OK].
11. Use the numeric keys to specify the folder to
which the job is to be sent (up to 120characters),
then press [OK].
12. Press [ ] or [ ] to select <LOGIN NAME>,
then press [OK].
13. Use the numeric keys to enter the login name,
then press [OK].
You can enter up to 24 characters for the login name.
14. Press [ ] or [ ] to select <PASSWORD>, then
press [OK].
15. Use the numeric keys to enter the password,
then press [OK].
You can enter up to 14 characters.
To register another one-touch key or coded dial code, repeat the
procedure from step 4.
16. Press [Stop/Reset] to return to the standby
mode.
To Next Page
