â– Points to Note on Installation
• Illustrations used in this procedure are those of the Booklet Finisher unless otherwise specified.
• Refer to "Order of Installation of Options" when installing this equipment.
• Since this machine is heavy (Staple Finisher: approx. 36kg, Booklet Finisher: approx. 60kg), 2 or more persons are required
to install it. Be sure to perform the work in accordance with the standard to handle a heavy load in each country.
• When moving this equipment after having unpacked it, be careful by placing a plate, etc. on areas with steps to prevent the
casters from hitting those steps. If the casters hit a step, the casters or the base plate may be deformed.
CAUTION:
When tightening the screws, do not tighten them too tightly. Otherwise, there is a risk of damage and deformation of screw
holes.
â– Order of Installation of Options
1. Buffer Pass Unit *1
2. Document Insertion Unit or Document Insertion/ Folding Unit
3. Puncher Unit
4. Jogger Kit
5. Staple Finisher or Booklet Finisher (This equipment)
6. Long Sheet Tray
*1:When installing the Finisher, it is necessary for the Buffer Pass Unit to be installed.
[1]
[2]
[2]
[5]
[5]
[3]
[6]
[4]
[6]
[4]
[3]
â– Product Name
Safety regulations require the product's name to be registered. In some regions where this product is sold, the following names
may be registered instead.
6. Paper Output Options
765
To Next Page
Loading...
Need help?
General