Canon imagePROGRAF iPF6300S Basic Guide No.2 User Manual

Cannot print over a network
Cannot connect the printer to the network ..................................................................................................... 1039
Cannot print over a TCP/IP network .............................................................................................................. 1039
Cannot print over a NetWare network ........................................................................................................... 1040
Cannot print over AppleTalk or Bonjour networks ......................................................................................... 1040
Cannot connect the printer to the network
Cause Corrective Action
The Ethernet cable
is not connected
correctly to the
printer's Ethernet
port.
1. Make sure the printer is connected to the network with the correct Ethernet cable, and then
turn the printer on. For instructions on connecting the cable, refer to the Setup Guide.
2. Make sure the Link indicator is lit.
The top and bottom indicators are lit if the printer is connected via 1000Base-T. The bottom
indicator is green if the printer is connected via 100BASE-TX, and the top indicator is orange
if connected via 10BASE-T.
If the Link indicator is not lit, check the following points.
• Make sure the hub is on.
• Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
• Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
• Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission rate
automatically (in auto negotiation mode), sometimes the hub settings cannot be detected.
In this case, configure the connection method manually, specifying the communication
mode in use.
(See "Configuring the Communication Mode Manually.")
→P.968
Cannot print over a TCP/IP network
Cause Corrective Action
The printer's IP address is not
configured correctly.
Make sure the printer's IP address is configured correctly.
(See "Configuring the IP Address Using imagePROGRAF Device Setup Utili-
ty.") →P.442
(See "Configuring the IP Address Using the Printer Control Panel.") →P.942
The printer's TCP/IP network
settings are not configured cor-
rectly.
Make sure the printer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI .")
→P.946
The computer you are trying to
print from is not configured cor-
rectly.
Make sure the computer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer Driver Destination (Windows).") →P.945
(See "Configuring the Destination in TCP/IP Networks .") →P.960
Troubleshooting > Cannot print over a network >
iPF6300S Cannot connect the printer to the network
12
1039

Canon imagePROGRAF iPF6300S Basic Guide No.2 Specifications

General

Brand	Canon
Model	imagePROGRAF iPF6300S Basic Guide No.2
Category	Printer
Language	English