4. Press â–² or â–¼ to select the type of paper, and then press the OK button.
Note
• When VacuumStrngth is set to Automatic, the setting value selected for the previous print job is
displayed (to the right of Automatic ) once you select the type of paper currently supplied.
However, the value is cleared when the printer is turned off or the paper is replaced.
5. Press â–² or â–¼ to select VacuumStrngth, and then press the OK button.
6. Press â–² or â–¼ to select the desired setting value, and then press the OK button.
Adjustments for Better Print Quality
>
Adjusting the feed amount
>
iPF6300S Adjusting the Vacuum Strength (VacuumStrngth)
7
843