1-6
Print Plug-In for Photoshop
Chapter 1 Installing Print Plug-In
Starting the Print Plug-In
The procedures to start the Print Plug-In are as follows.
1. Start Photoshop.
2. Open the RGB color image that you wish to print.
3. If required, select the print range.
4. Select Export (or Data Export) from the File menu and then select the output plug-in that
matches your printer.
Output plug-ins you can select are as follows.
W6400PG Output Plug-in
W8400PG Output Plug-in
W2200 Output Plug-in
Note
Images for use with Print Plug-In are not more than 30,000 pixels in width
and height. Reduce the selection range or reduce the image with processing
for images over 30,000 pixels in width and height and then attempt step 3.
To Next Page
Loading...
Need help?
General