Copying Separately-set Originals (Job Build)
2-45
Useful Copy Functions
2
Copying Separately-set Originals (Job Build)
This mode enables you to scan too many originals to set at once, by dividing them into
multiple batches. You can use both the feeder and the platen glass for scanning. The
originals are copied as one document after all batches have been scanned.
IMPORTANT
• You cannot change the copy settings while scanning originals in the Job Build mode. You need to
set the necessary settings beforehand according to the type of original or the desired Finisher
mode.
• However, you can change or specify the following before scanning the next originals, i.e.,
between jobs: the number of copies, image quality, exposure and 2-sided mode.
• When you place each original in the feeder, continue to remove each original from the original
output area when scanning is completed.
NOTE
•
When you place different-size originals in the feeder, set the Different Size Originals mode.
•
When you want to copy one-sided and two-sided originals as two-sided copies, set the 1 2-Sided
mode beforehand, if the first batch of originals is one-sided. If the first batch is two-sided, then set
the 2 2-Sided mode beforehand. To scan the next original, set or cancel the Two-sided Original
mode according to the type of original.
•
It is useful to store originals in a mail box and print them with the Merge Documents mode when you
cannot prepare the originals at one time, or when you want to set different settings for each original.
(See the Mail Box Function Guide.)
1
Place your first original, and press “Special Features.”
Originals
Copies
To Next Page
Loading...
Need help?
General
