Canon iR5000i - Adjusting the Separation Roller Pressure; Orientation of the Separation Roller

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 5 PICK UP/FEEDING SYSTEM
5-59 P
9.2.9 Adjusting the Separation Roller Pressure
If double feeding or pickup failure oc-
curs during pickup, change the position
for the pressure spring of the separation
roller.
• If double feeing occurs, move the
spring in the direction of arrow B.
• If pickup failure occurs, change the
spring in the direction of arrow A.
[1] Feeding roller
[2] Separation roller
[3] Pressure lever
[4] Pressure spring
F05-902-14
9.2.10 Orientation of the Separation Roller
Keep the following in mind when replac-
ing the separation roller.
Mounting the separation roller
in the wrong orientation will
lead to interference against
crimping washer. Make sure it is
mounted in the correct orienta-
tion.
F05-902-15
[1]
[2]
A
B
[3]
[4]
Cassette 3/4
Right deck pickup assembly
Left deck pickup assembly
Wider groove
Narrower groove
(front of machine)
(rear of machine)
Wider groove
Narrow groove