CHAPTER 2 NEW FUNCTIONS
2-93
COPYRIGHT
©
2001 CANON INC. 2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
COPIER>ADJUST>CCD>PPR (density data of standard white pa-
per)
COPIER>ADJUST>CCD>PLT (density data of standard white plate)
COPIER>AJDUST>CCD>GAIN-E/O (gain adjustment input of CCD
output)
COPIER>ADJUST>CCD>OFST-E/O (offset adjustment input of CCD
output)
COPIER>ADJUST>CCD>SH_RATIO (white level ratio data of stan-
dard white plate and standard white paper during shading correc-
tion)
If a faulty image is generated after executing shading auto adjustment, enter
the parameter values indicated on the service label.
COPIER> ADJUST> CCD> EGGN-ST (Enter an adjustment value
for the end gain correction start position)
COPIER> ADJUST> CCD> EGGN-END (Enter an adjustment value
for the end gain correction end position)
Enter the edge gain correction value on the service label.
COPIER>ADJUST>AE>AE-TBL (text density adjustment for real-
time AE mode)
Use it to change the parameter for adjustment of the density correction
curve (for real-time AE mode; 10 steps).
Range: 0 to 9 (default: 4)
F02-503-05
White
White
Original density
Copy density
Lower setting
decreases text density
Higher setting
increases text density
To Next Page
Loading...
Need help?
General
