6-22
Optional Accessories
6
Network Board
cc
cc
100 Indicator (Green)
Comes on when the network board is connected to
the network by 100BASE-TX.
Does not come on when connected by 10BASE-T.
dd
dd
LNK Indicator (Green)
Comes on when the network board is connected to
the network properly.
ee
ee
ERR Indicator (Orange)
Comes on or blinks when the network board is not
working properly.
ff
ff
MAC Address
It is required when setting the IP address using the
ARP/PING command. It may be also required when
installing the printer driver.
Installing the Network Board
Install the network board in the expansion slot of the printer using the following
procedure. A Phillips screwdriver is required for installing the network board. Have
a screwdriver ready in advance that matches the size of the screws.
1
Turn the printer and computer OFF aa
aa
, remove the USB cable
bb
bb
, and then disconnect the power plug from the AC power
outlet cc
cc
.
2
Remove the power cord.
If there is not enough space to install the network board, move the printer to a
place where you can work easier.
c
b
a
a