Preparations 21
overseas travels or special power sources such as those on aircraft and
ships, DC-AC inverters, etc.
NOTES
• We recommend charging the battery pack in temperatures between
10 °C and 30 °C. If either the ambient temperature or the battery pack’s
temperature is outside the range of approx. 0 °C to 40 °C, charging will
not start.
• If the ambient temperature or the battery pack’s temperature is low,
charging may take longer than usual.
• The battery pack will be charged only when the camcorder is off.
• If the power supply was disconnected while charging a battery pack,
make sure the POWER/CHG indicator has gone out before restoring
the power supply.
• If remaining battery time is an issue, you can power the camcorder
using the compact power adapter so the battery pack will not be con-
sumed.
• Charged battery packs continue to discharge naturally. Therefore,
charge them on the day of use, or the day before, to ensure a full
charge.
• Battery packs for this camcorder can display the remaining battery time.
The first time you use a battery pack, fully charge it and then use the
camcorder until the battery pack is completely exhausted. Doing so will
ensure that the remaining recording time will be displayed accurately.
• We recommend that you prepare battery packs to last 2 to 3 times
longer than you think you might need.
Turning On the Camcorder
You can turn the camcorder on and off by opening and closing the LCD
panel. The first time you turn on the camcorder, the initial setup
screens will appear and guide you through the basic settings (A 29).
To Next Page
Loading...
Need help?
General