Canon MultiPASS MP390 Setup Sheet

Set-Up Sheet
Set-Up Sheet
Thank you for purchasing the Canon MultiPASS MP390. To prepare your machine for
use, please follow the instructions in this Set-Up Sheet before referring to any other
documentation.
READ THIS SHEET FIRSTREAD THIS SHEET FIRST
Do not connect the USB cable until , "Connect the USB
cable."
IMPORTANT
Setup procedures
Start
Setup flow
Setup procedures
End
This side explains the setup procedure for use without connecting to a computer. <Check packed contents, install and adjust machine>
These steps explain the setup procedure for use by connecting to a computer. <Install MP Drivers and Utility Software>
You can use the copy, photo print, fax functions.
You can use the print, PC fax, scan functions.
Connect
power cord
Connect
telephone line
Install Utility Software
Install print head
Install MP Drivers
Install ink tanks
Connect USB cable
Load print media
Align print head
Unpack and install
the machine
Unpack and install the machine.
1 Carefully remove all items from the box.
NOTE
When removing the machine from the
box, handle it with care and do not drop it.
2 Remove the protective material.
NOTE
After removing the protective material, do
not lift the machine by grasping the scan
unit.
Hold the bottom side.
3 Place the machine on a flat surface.
•Be sure to hold the machine by the
sides. Do not place anything in front
of the machine.
4 Remove all shipping tape from the
exterior of the machine.
•After removing the tape, remove the
protective sheet.
Do not grasp the
scan unit.
HT3-2145-000-V.1.0
Remove the
protective sheet.

Canon MultiPASS MP390 Specifications

General

Brand	Canon
Model	MultiPASS MP390
Category	All in One Printer
Language	English