98
E
Editing
Preparations
The tape in the camcorder:
When using the MVX2i’s AV insert function, only record to tapes recorded in
SP mode.
If there are non-recorded portions or portions recorded in a mode other than
SP mode on the tape, recording will stop.
The playback tape:
Use only tapes without non-recorded portions.
If there are non-recorded portions or changes in the recording mode, you
may not be able to insert AV correctly.
You cannot insert AV in the following cases:
• The playback tape has been poorly recorded.
• During special playback: fast forward playback, rewind playback or slow
playback etc. (analog only).
TV:
You cannot insert AV from a TV program with anomalous synchronized
signals, such as when the program itself received poor signals.
1. Connect the camcorder to the VCR.
2. Prepare the VCR and TV.
• Set the TV/Video selector on the televison to Video. For further details,
see “Connections for Playback on a TV Screen” on p. 34.
• Turn on the VCR and load a recorded cassette.
• See TV and VCR instruction manuals for details.
3. Turn the camcorder’s POWER switch to PLAY (VCR) and load
a recorded cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC
(closed position).
4. Move the camcorder’s TAPE/CARD switch to TAPE.
Example recording from a VCR
To Next Page
