##788 TX After transmitting EOR-EOP in ECM transmission, re-transmission of
the procedure signal has been attempted the number of specified
times but failed, or T5 time-over (60 sec.) has occurred.
##789 TX After transmitting EOR-EOP in ECM transmission, ERR has been
received.
##790 RX After receiving EOR-EOP in ECM reception, ERR has been
transmitted.
##791 TX / RX During the ECM mode procedure, a signal other than a significant
one has been received.
##792 RX In ECM reception, PPS-NULL between partial pages has not been
detected.
##793 RX During high-speed signal reception in ECM, no effective frame has
been detected, and a time-over has occurred.
(10/32)
To Next Page
Loading...
