##220 TX / RX System error (main program hang-up)
##224 TX / RX An error has occurred in the procedure signal in G3 transmission.
##226 TX / RX The stack pointer has shifted from the RAM area.
##229 RX The recording area has been locked for 1 minute.
##232 TX The encoder control unit has malfunctioned.
##237 RX The decoder control unit has malfunctioned.
##238 RX The print control unit has malfunctioned.
##261 TX / RX A system error has occurred between the modem and the system
control board.
##280 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##281 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##282 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##283 TX Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
##284 TX After TCF transmission, DCN has been received.
##285 TX After EOP transmission, DCN has been received.
##286 TX After EOM transmission, DCN has been received.
##287 TX After MPS transmission, DCN has been received.
##288 TX After EOP transmission, a signal other than PIN, PIP, MCF, RTP,
RTN has been received.
##289 TX After EOM transmission, a signal other than PIN, PIP, MCF, RTP,
RTN has been received.
##290 TX After MPS transmission, a signal other than PIN, PIP, MCF, RTP,
RTN has been received.
##670 TX In V.8 late start, the DIS V.8 ability from the receiving machine was
detected, and CI was sent in response; however, the procedure
failed, causing T1 time-over.
##671 RX In V.8 call reception, the procedure fails to proceed to phase 2 after
CM detection, causing T1 time-over.
##672 TX In V.34 transmission, the procedure fails to proceed from phase 2 to
phase 3 or later, causing T1 time-over
##673 RX In V.34 reception, the procedure fails to proceed from phase 2 to
phase 3 or later, causing T1 time-over
##674 TX In V.34 transmission, the procedure fails to proceed from phase 3 or
4 to the control channel or later, causing T1 time-over
##675 RX In V.34 reception, the procedure fails to proceed from phase 3 or 4 to
(7/32)
To Next Page
Loading...
