Setting Page
163
Set criteria in the video display area or [Detection Conditions] tab (P. 165). The detection criteria differ according
to the detection type.
Set which operations to carry out for video detection in the [Event] tab (P. 178).
The settings are saved to the camera.
To restore settings, click [Clear] before applying. This discards the settings you have specified and restores the settings saved in
the camera. However, note that detection settings only added to the detection setting area by clicking [Add] are all discarded.
You can check the detection status of the specified detection settings in video display area, the [Event] column in
[Detection Settings] or the [Event and Input/Output] menu in the Camera Viewer (P. 72).
Setting a Non-Detection Area
You can set an area where changes are not detected, to prevent mis-detection and non-detection.
5
Configure the detection criteria.
6
Configure event settings.
7
To register multiple detection settings, repeat steps 2 to 6.
8
Click [Apply].
9
Check the detection result.
To Next Page
Loading...
