200
• Host Access Restrictions
• Time Zone
• Certificates
• Private Key
•IPsec
If you set this to [Do not save], the above settings are also initialized.
Since the administrator account is also initialized, you will become unable to connect to the camera. Use the Camera
Management Tool to configure the initial settings.
[Restore Default Settings]
The initial settings are restored according to the selection in [Network Settings] after rebooting.
• It is recommended that you back up each current setting before you click [Exec] in [Restore Default Settings].
• The camera can also be restored to factory default settings using the reset switch. Note, however, that this will reset all camera settings
to factory default settings except for date and time (P. 225).
To Next Page
Loading...
