98
English
Problem Possible cause Solution
The volume is
limited to a value
less than 70.
In the Max Volume [VOL] menu, a maximum
volume
less than 70 was selected.
Increase the value according to
chapter Max. Volume [VOL].
A speaker shows
WLS in the display.
1. The slave speaker is operated
without the BRA 3 / VRA 3.
1. Turn on the BRA 3 / VRA 3.
2. The slave speaker is not paired yet. 2. Pair the slave speaker with the BRA 3 / VRA 3 according
to chapter
WSP
.
The subwoofer does
not reproduce sound.
1. The subwoofer is not paired yet. 1. Pair the slave speaker with the BRA 3 / VRA 3 according
to chapter
WSP (
Wireless Speaker Pairing).
2. The subwoofer is connected to the BRA 3 /
VRA 3 using a RCA cable, but Sub Out is set to
Off(not activated.
2. Activate the output Sub Out (ON) at the Sub Out menu.
No connection can be
established between
the router and the
BRA 3 / VRA 3.
1. The DHCP server is deactivated in the router. 1. Activate the DHCP server of the router according to the
router's instructions.
2. A filter for MAC addresses was created in the
router..
2. Deactivate the MAC Address Filter.
3. Your router is not compatible with Chromecast
built-in.
3. Routers that are demonstrably compatible can be found in
the web link in the chapter “Using Chromecast built-in for
audio”. However, there are more compatible routers.
Your WLAN network
is not displayed during
setup.
1. The network connection for the BRA 3 /
VRA 3 is set to Ethernet [ETH].
1. Change the setting to WiFi [WIF].
The BRA 3 / VRA 3 is
not indicated in the app
on your (mobile) device.
2. Device and BRA 3 / VRA 3 must be conncted
to the same network.
2. Connect device resp. BRA 3 / VRA 3 to the corresponding
network (e.g. when using a guest network)
To Next Page
Loading...
Need help?
General
