CANYON FURNITURE COMPANY
1.- USE THE LONG END OF THE ALLEN WRENCH TO FASTEN BOLTS LOOSELY AND QUICKLY.
2.- USE THE SHORT END OF THE ALLEN WRENCH FOR FINAL TIGHTENING.
TIPS : SEE ILLUSTRATION BELOW
(91/92/93-705 ) CHARCOAL COLLECTION STUDENT BUNK BED ASSEMBLY INSTRUCTIONS
READ ALL THE INSTRUCTIONS AND IDENTIFY ALL COMPONENTS AND CHOOSE YOUR CONFIGURATION AND BE SURE YOU HAVE ALL PARTS
TWO PEOPLE ARE NEEDED TO ASSEMBLE.
THANK YOU FOR YOUR PURCHASE !
CONFIGURATION TYPE # 2
PLEASE CONTACT YOUR RETAIL STORE WITH SERVICE OR PARTS REPLACEMENT REQUESTPLEASE CONTACT YOUR RETAIL STORE WITH SERVICE OR PARTS REPLACEMENT REQUEST
CONFIGURATION TYPE # 1CONFIGURATION TYPE # 1
DO NOT COMPLETELY TIGHTEN ALL BOLTS UNTIL ALL COMPONENTS ARE CONNECTED.
TOOLS NEEDED
PHILIPS HEADSCREWDRIVER (NOT INCLUDED)
5MM ALLEN WRENCH (INCLUDED)
TIPS # 1
TO ASSEMBLE THIS BUNK BED REQUIRES
TWO PERSONS
THE BED SLATS WILL NO SUPPORT A
MATTRESS ALONE,A SLAT PACK OR A
BUNKIE BOARD IS REQUIRED FOR
PROPER SAFETY.
( NOT INCLUDED )
92-705 LOFT BED END
92-706 BUNK BED END
92-711 5 DRW STUDENT LOFT CHEST
92-730 6 PCS SIDE RAILS
92-709 FULL BED
92-645 4 PCS SLAT PACK 3/3
92-646 4 PCS SLAT PACK 4/6
92-705 LOFT BED END
92-706 BUNK BED END
92-710 3 DRW STUDENT LOFT DESK
92-730 6 PCS SIDE RAILS
92-709 FULL BED
92-645 4 PCS SLAT PACK 3/3
92-646 4 PCS SLAT PACK 4/6
92-705 LOFT BED END
92-706 BUNK BED END
92-711 5 DRW STUDENT LOFT CHEST
92-730 6 PCS SIDE RAILS
92-709 FULL BED
92-601 FOLDING DESK
92-645 4 PCS SLAT PACK 3/3
92-646 4 PCS SLAT PACK 4/6
92-705 LOFT BED END ( 2 BOXES )
92-710 3 DRW STUDENT LOFT DESK
92-711 5 DRW STUDENT LOFT CHEST
92-730 6 PCS SIDE RAILS
92-707 TWIN BED
92-720 LADDER
92-645 4 PCS SLAT PACK 3/3 ( 2 BOXES )
92-705 LOFT BED END ( 2 BOXES )
92-711 5 DRW STUDENT LOFT CHEST ( 2BOXES )
92-730 6 PCS SIDE RAILS
92-707 TWIN BED
92-720 LADDER
92-601 FOLDING DESK
92-645 4 PCS SLAT PACK 3/3 ( 2 BOXES )
TIPS # 2
REV 01 14/04/2016
PAGE 1 OF 5
KIS01112
To Next Page
Need help?
General
