Caple C981G - Gas Type Selection (C1081 G)

33Instruction manual C981G & C1081GPlease keep this instruction manual for future reference
CHOOSING THE TYPE OF GAS (C1081G )
The hob can be configured for use with natural gas or LPG. To activate the gas selection procedure the
hob must be switched on with all of the burners off.
Press the “-” buttons simultaneously for approx. 3 seconds as shown in the figure above. The
burner level display will switch off and “Met” or “LPG” will appear on the timer display,
depending on the current configuration.
Select the desired setting using the “+” and “-” buttons.
To complete the procedure, press the timer button.
By activating this function, any other previously set burner switch off times will be cancelled.
met
met
CHOOSING THE TYPE OF GAS (C1081G )
The hob can be configured for use with natural gas or LPG. To activate the gas selection procedure the
hob must be switched on with all of the burners off.
Press the “-” buttons simultaneously for approx. 3 seconds as shown in the figure above. The
burner level display will switch off and “Met” or “LPG” will appear on the timer display,
depending on the current configuration.
Select the desired setting using the “+” and “-” buttons.
To complete the procedure, press the timer button.
By activating this function, any other previously set burner switch off times will be cancelled.
met
met
CHOOSING THE TYPE OF GAS (C1081G )
The hob can be configured for use with natural gas or LPG. To activate the gas selection procedure the
hob must be switched on with all of the burners off.
Press the “-” buttons simultaneously for approx. 3 seconds as shown in the figure above. The
burner level display will switch off and “Met” or “LPG” will appear on the timer display,
depending on the current configuration.
Select the desired setting using the “+” and “-” buttons.
To complete the procedure, press the timer button.
By activating this function, any other previously set burner switch off times will be cancelled.
met
met
CHOOSING THE TYPE OF GAS (C1081G)
The hob can be configured for use with natural gas or LPG. To activate the gas selection procedure
the hob must be switched on with all of the burners off.
Press the “-” buttons simultaneously for approx. 3 seconds as shown in the figure above.
The burner level display will switch off and “Met” or “LPG” will appear on the timer display,
depending on the current configuration.
Select the desired setting using the “+” and “-” buttons.
To complete the procedure, press the timer button.
By activating this function, any other previously set burner switch off times will be cancelled.