27
The control panel displays [ E ]:
• The electronic system is defective.
• Disconnect and reconnect the hob at the circuit breaker.
One or all cooking zone cut-off:
• The safety system is activated.
• You forgot to turn off the cooking zone for a long time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of power level to prevent overheating
Continuous ventilation after turning off the hob:
• This is not a failure; the fan continues to run to protect the electronic components.
• The fan cooling stops automatically.
The automatic cooking system doesn’t start-up:
• The cooking zone is still hot [ H ].
• The highest power level is set [ 9 ].
The control panel displays [ ]:
• Refer to the chapter “control panel locking”.
The control panel displays [ ] or [ ] or [ ]:
• Refer to the chapter “Pan programs”.
The control panel displays [ II ] or [ ► ]:
• Refer to the chapter “Pause”.
The control panel displays [ E8 ]:
• The air inlet of the ventilator is obstructed, release it.
The control panel displays [ Er21 ]:
• The hob is overheated, switch off, let it cool and then turn it on again.
The control panel displays [ Er31 ]:
• The hob is not connected to the network. Check the connection and reconnect the hob.
The control panel displays [ Er47 ]:
• The hob is not connected to the network. Check the connection and reconnect the hob.
The control panel displays [ Er61 ]:
• The hob is not connected to the network. Check the connection and reconnect the hob.
The control panel displays [ Er62 ]:
• Pan position not clear. Move the pan to another position.
If one of the symbols above persists, contact Caple Service.
T - 0117 938 7420
E - service@caple.co.uk.
To Next Page
Loading...
