Instruction manual C995i 25
Please keep this instruction manual for future reference
BEFORE INSTALLING THE HOB, MAKE SURE THAT:
› The induction hob must be installed by qualified personnel or Caple technicians. Please never
conduct the installation yourself.
› Check the work surface is square and level, and no structural members interfere with space
requirements.
› Check the work surface is made of a heat-resistant material.
› If the hob is installed above an oven, the oven has a built-in cooling fan.
› The installation will comply with all clearance requirements and applicable standards and
regulations.
› Ensure a suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
› The isolating switch must be of an approved type and provide a 3mm air gap contact separation
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of
the requirements).
› The isolating switch will be easily accessible to the customer once the hob is installed.
› You consult local building authorities and by-laws if in doubt regarding installation.
› You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces.
AFTER INSTALLING THE HOB, MAKE SURE THAT:
› Ensure the power supply cable is not accessible through cupboard doors or drawers.
› Ensure there is adequate flow of fresh air from outside the cabinetry to the base of the hob.
› If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
below the base of the hob.
› The isolating switch must be easily accessible by the customer.
BEFORE LOCATING THE FIXING BRACKETS
› The unit should be placed on a stable, smooth surface (use the packaging).
› Do not apply force onto the controls protruding from the hob.
To Next Page
Loading...
